r17473 - /trunk/docs/latex/curvefit.tex -- September 06, 2012 - 16:07

Author: bugman
Date: Thu Sep  6 16:07:04 2012
New Revision: 17473

URL: http://svn.gna.org/viewcvs/relax?rev=17473&view=rev
Log:
A few small edits of the relaxation curve-fitting chapter.

This is to reinforce the exact time of the relaxation time period.


Modified:
    trunk/docs/latex/curvefit.tex

Modified: trunk/docs/latex/curvefit.tex
URL: 
http://svn.gna.org/viewcvs/relax/trunk/docs/latex/curvefit.tex?rev=17473&r1=17472&r2=17473&view=diff
==============================================================================
--- trunk/docs/latex/curvefit.tex (original)
+++ trunk/docs/latex/curvefit.tex Thu Sep  6 16:07:04 2012
@@ -307,7 +307,7 @@
 spectrum.replicated(spectrum\_ids=[`T2\_ncyc11\_ave', `T2\_ncyc11b\_ave'])
 \end{exampleenv}
 
-For the Sparky peak lists, by default relax assumes that the intensity value 
is in the 4$^\textrm{th}$ column.  A typical file looks like:
+Note that the relaxation time period should be calculated directly from the 
pulse sequence (as the sum of delays and pulses for the peroid), as the 
estimated time may not match the real time.   For the Sparky peak lists, by 
default relax assumes that the intensity value is in the 4$^\textrm{th}$ 
column.  A typical file looks like:
 
 {\scriptsize \begin{verbatim}
      Assignment         w1         w2   Data Height
@@ -570,9 +570,9 @@
 \centerline{\includegraphics[width=0.8\textwidth, bb=14 14 1415 
1019]{graphics/screenshots/r1_analysis/peak_intensity_times.eps.gz}}
 \end{minipage}
 
-All delays in the pulse sequence should be carefully checked to be sure that 
the time is exactly what you would expect.  To set the time and close the 
wizard, click on the \guibutton{Finish} button.
-
-This procedure should be repeated for every experiment you have collected.  
In the end you should see something such as:
+All delays and pulse lengths in the pulse sequence should be carefully 
checked to be sure that the time is exactly what you would expect -- the 
estimated time may not match the real time.  To set the time and close the 
wizard, click on the \guibutton{Finish} button.
+
+This procedure should be repeated for every experiment you have collected 
(you could, as an alternative, load all at the same time using the 
\guibutton{Apply} button at each stage).  In the end you should see something 
such as:
 
 \begin{minipage}[h]{\linewidth}
 \centerline{\includegraphics[width=0.8\textwidth, bb=14 14 1415 
1019]{graphics/screenshots/r1_analysis/analysis_tab_full.eps.gz}}